Changing The Light Bulbs - Amana A8RXNGFBS Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Dry Erase Board
(on some models)
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
Your Amana
®
JOT™ refrigerator is equipped with a special
technology (Dry Erase) on the door's surface, which allows you to
draw and write on it and erase easily; to keep the refrigerator door
in good condition, it is necessary to follow the instructions below:
IMPORTANT: Only the metal surface of the door is prepared with
the Dry Erase technology, which is why the markers should not be
used on any plastic parts or on the sides of the refrigerator. If
markers are used by mistake on plastic parts or on the side of the
refrigerator, it is recommended to clean immediately with liquid
dish detergent and water. For assistance in case of prolonged
exposure to the marker's ink, please visit our website at
www.amana.com or call the Amana Appliance Customer Service
toll free number at 1-800-843-0304. In Canada, visit our website
at www.amanacanada.ca or call us at 1-800-807-6777.
1. Remove the marker kit, which is included inside your
refrigerator. Place the marker kit horizontally somewhere in
your kitchen.
2. For best results, use Crayola
these recommended colors: black, blue, purple, orange,
yellow or brown. Do not use red or green. Always use a
marker designed for dry erase surfaces.
IMPORTANT: Do not use permanent markers.
3. The included markers are designed to be erased without
water. The marker's ink can be removed easily without water
with a cotton cloth or, in its absence, with a sponge, detergent
and water. If there is any ink residue left from prolonged
exposure, clean with liquid dish detergent and water.
4. Always use marker on the refrigerator's clean surface (free of
grease and dirt). For cleaning and care of your refrigerator, you
should clean the ink residues from the dry erase surface at
least once a month.
®
brand dry erase markers in

Changing the Light Bulbs

NOTE: Not all appliance bulbs will fit your refrigerator. Be sure to
replace the bulb with one of the same size, shape, and wattage.
Refrigerator Light
1. Unplug refrigerator or disconnect power.
2. Reach behind the control panel and unscrew the bulb.
3. Replace the bulb with a 40-watt appliance bulb.
4. Plug in refrigerator or reconnect power.
Freezer Light
1. Unplug refrigerator or disconnect power.
2. Remove the freezer shelf.
3. Remove the freezer light shield by pushing down.
4. Remove the light bulb and replace with one of the same size,
shape and wattage.
5. Replace the light shield.
6. Plug in refrigerator or reconnect power.
11

Publicidad

Tabla de contenido

Solución de problemas

loading

Tabla de contenido