Troubleshooting Procedures - Kohler K-1109 Manual Del Usuario

One-Year Warranty - For Mexico (cont.)
IMPORTER:
INTERNACIONAL DE CERMICA, S.A. DE C.V.
AV. CARLOS PACHECO NO. 7200
CHIHUAHUA, CHIH., MEXICO C.P. 31060
TEL: 52 (14) 29-11-11

Troubleshooting Procedures

This troubleshooting guide is for general aid only. A Kohler Authorized Service Representative or qualified
electrician should correct any electrical problems. For warranty service, contact your dealer or wholesale
distributor.
Symptoms
1. Whirlpool does not start/stop.
2. Motor starts, but all jets are not
functioning.
3. Whirlpool stops by itself.
4. Noisy operation.
5. Heater does not operate.
1010997-5-E
Probable Causes
A. No power to pump motor.
B. Air actuator does not work.
C. Pump motor does not work.
A. Jet is closed.
B. Jet not installed correctly.
C. Jets are blocked.
A. GFCI or ELCB trips.
B. Suction is blocked.
C. Jets are blocked.
D. Motor overheated and
protectoin device activated.
A. Pump banding straps have not
been cut. (models with wooden
support blocks only)
B. Dry or dislodged jet O-ring
(squeal).
A. No power to heater.
B. Water temperature exceeds
104° F (40° C).
C. Heater does not work.
8
Recommended Action
A. Set/Reset GFCI or ELCB
breaker; check wiring. If the
problem persists, refer to
installer/dealer.
B. Check air tube connections.
Replace air actuator. Refer to
installer/dealer.
C. Replace pump motor. Refer to
installer/dealer.
A. Rotate jet trim
counterclockwise to open.
B. Reinstall jet; check for O-ring
damage.
C. Remove blockage.
A. Identify source of fault and
correct. If problem persists,
refer to installler/dealer.
B. Remove obstruction.
C. Remove blockage.
D. Check for blockage at motor
vents. Remove bloackage and
allow motor to cool.
Check for suction blockage.
Remove blockage and allow
motor to cool.
Check for jet blockage. Remove
bloackage and allow motor to
cool.
A. Cut pump banding straps with
tin snips.
B. Remove jet, replace and
lubricate O-ring, and reinstall
jet.
A. Set/Reset GFCI or ELCB
breaker.
B. Allow water to cool; heater
will re-engage.
C. Replace heater. Refer to
installer/dealer.
Kohler Co.