Installing The Dk Roll - Brother QL-650TD Guia Del Usuario

3 Installing the DK Roll

1
Check that the power is turned OFF (check
LCD and LED lamp).
Lift up the DK Roll cover by the tabs at the
sides of the cover.
2
Pull up the roll release lever and
remove the protective sheet of
printing unit.
Then, remove the protective
battery sheet.
3
Insert the spool of the DK Roll
along the spool guide of the
printer.
Check the both sides of spool of DK
Roll are correctly inserted into
spool guide of the printer.
4
Check that the roll release lever
is in the up position.
Insert the edge of DK Roll into
the slot until it is just in front of
the cutter.
Protective battery sheet
Roll release lever
Printing unit protective sheet
Spool
Spool guide
Roll release lever
Cutter
Printing unit
23
STEP
1
STEP
2
STEP
3