Enable Rec; Schedule; Day; All Day - urmet domus 1093/061S Guía Rápida

2.3.1.7

Enable rec

This option is used to enable or disenable selected camera recording. To enable, select the respective check box using "◄►"
and press "ENTER" or "EDIT".
Symbol " " indicates that the recording option is enabled; symbol "×" indicates that it is not.
2.3.1.8

Schedule

Select "Schedule" and press "ENTER" to access the programming menu shown below.
The selected item is highlighted.
Press arrows "◄►▲▼" to p
Point the cursor to the requ
selected menu item.
Select "CONFIRM" and press "ENTER" to make the changes effective.
Select "CAN CEL" a nd press "ENTER" to cancel the chan
Press "ESC" to go back by one step.
Press "ESC" several times until the configuration w
IMPO RTANT NOTE
•
The device will resume recording only recording tasks programmed in the "Registrazione" menu after a
blackout. Recordings started manually will not be resumed after a blackout.
2.3.1.8 .1

Day

This opt ion is used to set and program recordin
Use "▲ ▼" to select.
This op tion can be used to set up to 4 recording periods for each day of the week with respective event start and end times. The
recording mod e can be defined
2.3.1.8.2 A ll day
You can also enable recording for the entire selecte
To enable, select the respective check box using "◄
Symbol " " indicates tha t the whole day recording option is enabled; symbol "×" indicates that it is not.
Check the "All day" option to define the recording mode.
The following recording modes can be selected:
all time
mot det
alarm
mot / alm
mot & alm
command
In this mode, recording is continuous for 24 hours.
IMPORTANT NOTE
If "All Time" is selected, in the event of a blackout or if the device is switched off, the device will automatically resume recording
as soon as network voltage is resumed and the device is switched on again.
In this mode, recording starts as soon as motion is detected.
DS1093-022
Figure 27: recording programming menu
oint the cursor to the various menu items.
ired item and press "ENTER" to ed
indow closes to quit the configuration menu.
g on the selected camera for day of the week.
for each period.
d day.
►" and press "ENTER" or "EDIT".
it it. Use buttons "▲▼" to change the available options for the
ges.
All time
Motion
40