GE 20673 Manual De Instrucciones página 17

The following procedure should
correct most fan wobble. Check
after each step.
Check that all blade and blade
bracket screws are secure.
Most fan wobble problems are
caused when blade levels are
unequal. Check this level by
selecting a point on the ceiling
above the tip of one of the blades.
Measure from a point on the center
of each blade to the point on the
ceiling. Measure this distance as
h s o w n n i f g i u e r R . o a t
until the next blade is positioned
for measurement. Repeat for each
blade. Measurements deviation
should be within 3 mm (1/8 in.). Run
the fan for 10 minutes.
Warning: Do not bend blades if the
measurement is off.
Use the enclosed Blade Balancing
Kit if the blade wobble is still
noticeable.
Blade Balancing
e t h t e a f n
17