User Servicing Instructions; Troubleshooting - GE 20673 Manual De Instrucciones

PRODUCT MAINTENANCE
Here are some suggestions to help you maintain your fan.
Because of the fan's natural movement, some connections
may become loose. Check the support connections, brackets,
and blade attachments twice a year. Make sure they are
secure. (It is not necessary to remove fan from ceiling.)
Clean your fan periodically to help maintain its new
appearance over the years. Use only a soft b rush or lint-free
c o l h t o t a o v d i s r c t a h c
a lacquer to minimize discoloration or tarnishing. Do not
use water when cleaning. This could damage the motor, the
wood, or possibly cause an electrical shock.
There is no need to oil your fan. The motor has permanently
lubricated sealed ball bearings.
Note: Installation videos for fans with GE Powerplug quick connection
technology can be viewed and download on www.gelightingandfans.com

TROUBLESHOOTING

PROBLEM
Fan will not start
Fan sounds noisy
The LED will not light
Remote control
is a trademark of General Electric Company
and is under license by SQL Lighting and Fans, LLC
4400 North Point Parkway, Suite 154, Alpharetta, GA 30022

User Servicing Instructions

n i g h t f e n i s i . h h T e l p t a
SOLUTION
-Check main and branch circuit fuses or breakers.
-Check to make sure the wall switch is in the on position.
-Check to make sure the wiring to the powerplug receptacle is correctly done with the
live wire inserted and secured into the powerplug receptacle terminal.
-Make sure all motor housing screws are snug.
-Make sure the screws that attach the fan blade bracket to the motor hub is tight.
-Make sure wire nut connections are not rattling against each other on the interior wall
of the switch housing.
-Allow a 24-hour "breaking-in" period. Most noises associated with a new fan
disappear during this time.
-Make sure there is a short distance from the ceiling to the canopy. It should not touch
the ceiling.
-Make sure your ceiling box is secure.
-Ensure the pin connector is attached/inserted correctly.
-Ensure the power supply is turned on.
-Ensure the circuit breaker is set to "ON" position.
-Ensure batteries are new and installed correctly.
-Pair the remote control by following the pairing procedure on page 16 item 5.
n i g s i e s a e l d i w h t
ARNING: Make sure the power is off
at the electrical panel box before
you attempt any repairs. Refer
to the section "Making Electrical
Connections", page 8.
V1.2016
19