Reversing The Door Swing (Optional) - Maytag Commercial MLE24PD Instrucciones De Instalación

REVERSING THE DOOR SWING (OPTIONAL)

You can change your door swing from a right-side opening to a
left-side opening, if desired.
B
1. Open dryer door. Remove bottom screws from cabinet side of
hinges (A). Loosen (do not remove) top screws from cabinet
side of hinges.
2. Lift door until top screws in cabinet are in large part of
hinge slot. Pull door forward off screws. Remove top
screws from cabinet.
3. Remove screws attaching hinges to door.
4. Remove screws from all sidess of door (5 screws). Grasp
sides of outer door and gently lift to separate it from inner
door (do not pry apart). Do not pull on door seal or plastic
door catch.
C
A
EU - DECLARATION OF CONFORMITY
CE - DECLARATION DE CONFORMITE
BAUKNECHT HAUSGERÄTE GmbH, D-73614 Schorndorf
WE (nous):
WHIRLPOOL EUROPE S.r.l I-21025 COMERIO
representing (représentant):
declare under our sole responsibility that the product
déclarons sous notre propre responsabilité que le produit
Maytag
dryer
(sèche-linge) :
Maytag
to which this declaration relates is in conformity with the following standard(s) or other
normative document(s)
auquel se référe cette déclaration est conforme aux normes suivantes ou autres documents normatifs
EN 60335-1:2002+A1+A2+A11+A12+A13
EN 60335-2-11:2003+A1+A2
EN 62233:2008
EN ISO 10472-1:2008
EN ISO 10472-4:2008
EN 55014-1:2006
EN 55014-2:1995+A1:2001
EN 61000-3-12:2005
EN 61000-3-11:2000
following the provisions of Directive(s):
suivant les prévisions des Directives :
2006/95/EC LOW VOLTAGE DIRECTIVE
2004/108/EC ELECTROMAGNETIC COMPATIBILITY DIRECTIVE
Electro-magnétique)
2006/42/EC MACHINERY DIRECTIVE
Schorndorf, 29.04.2010
Place and date:
lieu et date :
5. Reattach outer door panel to
inner door panel so handle
is on the side where hinges
were just removed.
6. Attach door hinges to dryer door so that the larger hole is
at the bottom of the hinge and the hinge pin is toward the
door front.
7. Remove the 4 screws that attach 2 plugs (B) on the handle
side. Attach plugs to opposite side using the same 4 screws.
8. Insert screws into bottom holes on left
side of cabinet. Tighten screws halfway.
Position door so large end of door hinge
slot is over screws. Slide door up so
screws are in bottom of slots. Tighten
screws. Insert and tighten top
screws in hinges.
9. Close door and check that door strike aligns with door
catch (C).
MLE24PD
MLE24PN
(CEE Directive Basse Tension)
(CEE Directive Compatibilité
represented by
Roberto Mottura
Director PDC, FC
Name and signature of authorised person
Nom et signature de la personne autorisée
9