Publicidad
12400 Earl Jones Way, Louisville, KY 40299
(800) 626-1126 | www.rev-a-shelf.com
TOOLS REQUIRED:
A
B
C
D
NOTE: IT IS VERY IMPORTANT THAT YOU FOLLOW THESE DIRECTIONS CAREFULLY. THE FIXED
(CYLINDER) END OF THE DAMPENER MUST BE INSTALLED AT THE TOP LOCATION FOR
LUBRICATION OF THE DAMPENER TO MAINTAIN PROPER FUNCTION. THE RETAINING CLIPS
MUST BE USED FOR SAFE OPERATION OF THE ASSEMBLY.
1) Put (2) lock washers on the threaded end of
(2) ball studs, screw into the arm assembly of the
mixer lift and then tighten with a ½" wrench.
1/2"
Description
Dampeners
Ball Studs
Lock Washers
Retaining Clips
*FOR EXISTING MIXER LIFT, GO TO PAGE 3.
ESTIMATED ASSEMBLY
TIME:
15 MIN
A
QTY
2
4
4
B
4
2) Pull the ends of the dampener apart
about ½". (This will be slightly difficult due
to the dampening effect of the cylinder.)
1
INSTALLATION
INSTRUCTIONS
MIXER LIFT DAMPENER
CARE AND MAINTENANCE:
CLEAN WITH A DAMP CLOTH
AND WIPE PARTS DRY.
C
D
SOFT-CLOSE
I-MLHDSC-TRI-0415
Publicidad
