Publicidad
3) Insert the fixed (cylinder) end of the dampener
onto the top ball stud (on arm with rounded back
end) and press until it snaps on.
5) Insert (2) retaining clips into (2) ball connectors by sliding the tall end into the bottom hole
of the connector, pushing it through top hole and rotating to snap on at the bottom of the
ball. (If the clip is difficult to go into the hole, you may have to turn the ball connector to center
it on the ball stud)
6) Repeat steps 1-5 for the other arm assembly.
2
4) Rotate the movable (shaft) end of the dampener
to the other ball stud and snap on.
I-MLHDSC-TRI-0415
Publicidad
