Silverline 621444 Manual Del Usuario página 6

GB
Attaching the Straps
Fig. VI
• Feed the 1200mm Straps (9) through the Spring Lock Buckles (13)
• Feed the 930mm Straps (10) through the Plastic Buckles (5)
Operation
Adjusting the carrier angle
Fig. VIII
1. Slacken the Locking Mechanism Knobs (14) by turning anti-clockwise to disengage the Toothed
Angle Adjustment Cogs.
6
Fig. VII
Fig. IX
20°
2. Adjust the carrier so there is a minimum of a 20° upward angle from the horizontal position away
from the vehicle once in final position.
3. Ensure the teeth on the Angle Adjustment Cogs align correctly and retighten the Knobs
Fitting the carrier
Fig. X
1. Ensure the vehicle tailgate/bumper are clean before installation
2. Once the carrier is correctly assembled, open the tailgate and hook the upper straps over the top
edge of the vehicle tailgate
3. Close the tailgate and tighten the upper straps until the slack in the straps is taken up.
Note: if the panel gap isn't sufficient to accommodate the hooks, a dumbbell fitting or similar will
be required to prevent damage to the vehicle or hooks.
IMPORTANT: Panel hooks should not be used to secure the carrier to glass edges or flexible panels.