Cleaning And Sanitizing - Vollrath 46670 Manual Del Operador

CLEANING AND SANITIZING

CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
To maintain the appearance and increase the service life, clean the
equipment daily.
NOTICE: Do not immerse the cord, plug or equipment in water or
any other liquid.
NOTICE: Do not use caustic or abrasive cleaners on this unit.
1. Turn the On/Off power switch to the "OFF" position.
2. Allow the equipment to cool completely before cleaning.
3. Remove the cutting board, cutting board base and drip pan.
4. Wash hands.
5. In a clean basin or sink, in a solution of clean warm water and
correctly-diluted food compatible sanitizing solution, soak and wash
the cutting board, cutting board base and drip pan.
6. Remove the parts from the basin or sink and allow them to air dry.
Or, wash the cutting board, cutting board base and drip pan in a
commercial dishwasher.
7. If a stain on the carving station base is not responsive to soap and
water, use an abrasive cleanser and buff with a light duty Scotch-
Brite™ pad, using a circular motion. Should the stain require
additional treatment, you may need to sand the surface lightly with a
fine sandpaper (220 grit or higher), then buff with a light duty
Scotch-Brite™ pad. DO NOT USE STEEL WOOL PADS.
8. For gray discoloration caused by cutting with metal utensils, clean
gently using a cleanser recommended for rust removal, such as
® ®
Zud or Bar Keepers Friend
9. For hard water deposits, scrub with a general cleanser, such as
®
Bon Ami .
10.Clean the breath guard with a high-quality glass cleaner.
11.Clean the tubing with a damp soapy sponge and dry immediately.
Contoured Carving Station Operator's Manual
.
MAINTENANCE (CHANGING HEAT LAMPS)
CAUTION
Burn Hazard
Allow equipment to cool before moving or cleaning.
1. Turn the On/Off power switch to the "OFF" position.
2. Allow the equipment to cool completely before proceeding.
3. Remove the heat lamp by unscrewing it from the heat lamp shade.
Use only heat lamps that are shatter resistant. Vollrath recommends:
Item Watts Voltage
46670 250 120
46671 175 230
46672 175 230
Discard old heat lamps in an environmentally responsibly manner.
4. Install new heat lamp into the heat lamp shade and tighten.
Heat Lamp – Heat Lamp –
Clear Red
GE 47724 or
Halco 404071
Halco 404066
Philips 128959 Philips 600530
Philips 128959 Philips 600530
3