Volume Control - NuTone SENSONIC MS-725 Instrucciones De Instalación

Flat edge

VOLUME CONTROL

If desired, the volume from the center channel speaker can
be controlled by using the 75 or 150 Watt NuTone
autoformer stereo volume control SVC-101 or SVC-102.
Refer to the stereo volume control instruction sheet for
further details.
CAUTION: The MS-725 is not designed to be used with
NuTone Radio Intercom Systems.
HOME THEATER SYSTEM
For best stereo/surround sound reproduction you must use all
speakers of the same brand in the system. The new NuTone
SENSONIC™ SURROUND SOUND 8 Ohm speakers are all
acoustically matched. Therefore, they can all be used in
combination to create sonically-balanced sound as it moves
across the screen in a home theatre surround sound system.
For the most accurate and exciting reproduction of bass
frequencies, a separate sub-woofer should be used.
A basic surround sound system consists of a pair of front
channel speakers, a pair of rear channel speakers and a
center channel speaker. You can use the in-wall speakers
MS-825, MS-828, MS-838K, or even ceiling speakers MS-625,
MS-626 as front and rear channel speakers. You can also use
the surface mount speaker MS-525 as a rear channel speaker.
The front channel speakers should be mounted at
approximately ear level from a seated audience at the front.
Rear channel speakers should be placed on the side walls
about 1 ⁄ to 2 ⁄ of the distance from the viewing screen or the
2 3
front of the room to the rear of the room. The bottom of the
speaker cabinet should be at least 2 feet above the ear level
of the seated audience. Rear channel speakers can also be
placed at the rear or back wall at about 2 feet higher than the
ear level of the seated audience as before. For best surround
effect, the distance to the rear speakers from the audience
should be no more than 6 feet.
One important aspect of surround mode is the speaker delay.
In other words, the sound to the rear speakers can be delayed
with respect to the front speakers to create the effect of
vastness of space. In most A/V receivers, this delay can be
controlled depending on personal taste. Usually in the
Sloping edge
Pro-Logic mode, this delay is controllable between 15-30
milliseconds.
For best sound imaging, place the center channel speaker
MS-725 above or below your TV in line with your main front
left and right channel speakers, and aim it directly at the
audience. Placing it beside the TV may not result in coinciding
the sound and picture, which is very important for optimum
FIGURE 1
surround effect.
A more elaborate sound system can be made by adding
MS-418 sub-woofer to enhance the bass frequency
reproduction. Placement of MS-418 in a room is not critical
since it primarily reproduces low frequency sounds, which are
non-directional. Place the sub-woofer in any convenient
location commensurate with your aesthetic and listening
preferences.
FEATURES
• Two 4" woofers with polymer-coated paper cone and poly
foam surround.
cooled ferrite magnet
• Video shielded
• Impedance: 8 Ohms
• Power handling capacity: 35 watts
• Frequency Response: 50-22,000 Hz
• Sensitivity, 1 m @ 1 W: 86 dB
• Protection: Automatic reset circuit breaker
1 ⁄ " polycarbonate tweeter with ferrofluid
2