Manhattan QUICKDOCK DUO Manual De Instrucciones página 2

QuickDock Duo
Read from / Write to an external drive
A Quick Dock is commonly used simply to work
directly on an external hard disk drive (HDD).
1. Use the included power adapter to connect
the DC Input jack (C) to an AC outlet.
2. Use the included USB cable to connect the
Dock (D) to your computer.
3. Set the Mode switch (E) on the back to PC.
4. Using one of the spacers (J) if needed, insert
an external drive (2.5" or 3.5") into the Dock
(A or B).
5. Press the On/Off button (F) and make sure
the R/W Power LED (G) lights. When the
external drive displays on your
computer, you can read or write
directly to it.
Cloning: Copying a hard disk drive
(HDD) without using a PC
1. Use the included power adapter to
connect the DC Input jack (C) to an
AC outlet. If necessary, disconnect
the Dock from your computer (D).
2. Set the Mode switch (E) on the back
to Clone.
3. Insert the source drive you're copying
from (A) and the target drive you're
copying to (B). Note: The capacity of
the target drive must be greater than that of the source drive. Any data
already on the target drive will be lost.
4. Press the On/Off button (F) and make sure the R/W Power LED (G) lights.
5. Press the Clone button (H) twice. The LEDs (I) indicate the progress (25-100%).
All four LEDs light when the copying process is complete.
6. Turn the power off; remove the drives.
• Don't turn off power to the Dock or remove a drive while any LED is blinking; that is, while any
data transfer is still in progress.
• Cloning time depends on the transfer rate: for example, 100 GB / SATA @ 60 MBps would take
about a half hour.
• For specifications, go to
2
ENGLISH
manhattanproducts.com.
A
DC
On/
PC Clone
Input
Off
C
F
Power
100% 75% 50% 25%
I
English
B
J
USB
3.0
E D
R/W
H
G
Clone