Operation - auna 10034060 Manual Del Usuario

EN
16

OPERATION

1. Switch on the Audio Source (TV set or audio component) that the
transmitter is connected to. The green LED indicator will glow
constantly.
2. Select the On/Off switch in the headset receiver to ON position, then the
blue signal LED indicator glows.
3. Adjust the volume for desired sound level, then place it on the head.
4. The signal blue LED indicator on the headset will blink slowly in every
minute when the battery level is low. Recharge the battery.
NOTE:
Make sure the headset is fully charged before first use. Charge the battery
for about 3 hours before first use.
RF transmission of the transmitter will automatically switch OFF in
approximately 5 minutes if there is no audio signal, or the signal that it
receives from the audio.
Source is too weak for proper reception. However, if the signal returns to an
acceptable level, the transmitter will automatically switch ON again.
Charging the headset
1. Select the On/Off switch in the headset receiver to OFF position.
2. Place the headphone receiver on the transmitter, make sure the charge
contact touches the charge pins on the transmitter.
3. The charging process starts automatically. LED indicator of main battery
then glows in red constantly. It will glow in green about 2 hours after the
battery is fully charged.
IMPORTANT
This unit must be operated with rechargeable
batteries only. When replacing the batteries
or when disposing of the unit, always comply
with applicable laws relating to the disposal of
batteries. Please place them in a proper disposal
container to ensure that they are eliminated safely
and in an environmentally friendly way.