Troubleshooting - GYS CONVERGYS 300 Manual Del Usuario

Translation of the original instructions
COMPATIBILITY
Before use, you must check the compatibility of your device with the Convergys:
Compatible devices: (maximum 300 W) :
• Office equipment: computers, scanners, printers etc ...
• Digital products: mobile phones, video cameras, DVD players etc ...
• Small devices: Flat screen TVs, fans, vacuum cleaners, irons etc ...
Non-compatible devices:
• The products exceeding the limit of the converter power: 300 W
• Products with high energy consumption: air conditioners, microwaves, high power electric drills, refrigerators etc...
Compatible devices with the USB port (5V - 2100 mA):
• USB port of Convergys is suitable to power compatible devices; it cannot be used to exchange data.
• Do not connect a device greater than 2100 mA as this may damage the USB port.
• Follow the manufacturer's recommendations if the device requires a specific charger.
OPERATION
300 W MODEL:
1) Choose desired connection:
• Directly onto battery: powers any device up to 300 W.
• Cigarette lighter: powers any device up to 150 W.
2) Connection:
Connect the red clip to the red «+» terminal of the converter and the black clip to the black «-» terminal of the conver-
ter; screw clips in place.
Caution: reversing the polarity may damage the converter.
3) Connect the converter:
• Wire: Connect the black clamp to the negative «-» terminal of the battery and then connect the red clamp to the
positive «+» terminal of the battery
Caution: If the clamps are not connected securely there is a risk of low/no power, cable overheating, damage to the
inverter supply, or fire.
• Cigarette lighter: Connect the cigarette lighter plug into the socket.
4) Switch the inverter ON (the green LED illuminates) and connect your equipment to the converter. (230V or USB 5V)
5) After use, unplug your equipment and then switch OFF the Convergys and disconnect it from the cigarette lighter or
the battery.

TROUBLESHOOTING

SYMPTOM
No voltage output
The device turns ON and
OFF intermittently
The inverter turns OFF
when a connected device
is switched ON
CONVERGYS 300
CAUSES
Bad connection
Weak battery
Thermal overload
Fuse failure (in the inverter or vehicle)
The direct load is too high.
The starting current is too high.
REMEDIES
Check the cigarette lighter plug and cable
connections
Check the vehicle battery
Start the engine of the vehicle if necessary
Stop the device. Leave the inverter to cool
ensuring adequate ventilation.
Check and replace fuse
Reduce the load
Check if the maximum power of the inver-
ter is suitable for the required power of the
device
EN
9 9