Battery Charger; Intended Use; Device Elements - Würth MLLR18 Traducción Del Manual De Instrucciones De Servicio Original

Battery charger

Read all safety precautions and
instructions. Failure to observe safety
precautions and instructions may lead
to electric shock, fire and/or severe
injury.
Protect the charger from rain
or moisture.
If water enters the charger, there is an
increased risk of electric shock.
Do not charge other batteries with
■
the charger. The charger is designed solely
for use with the batteries supplied with the
laser. If batteries of other manufacturers are
charged, there is a risk of fire and explosion.
Always check charger, lead and plug
■
before use. Do not use the charger
if it is damaged. Do not open the
charger yourself; if repair is neces-
sary it must be repaired by qualified
specialist personnel using original
spare parts only. Damaged chargers,
leads and plugs increase the risk of an electric
shock.

Intended use

The device is designed for determining and checking
lines which run exactly in horizontal and vertical
direction as well as rectangular lines and angles
using original Würth system accessories.
Any other use is considered improper.
The user is responsible for damage result-
ing from improper use.
12
Keep the charger clean. A soiled device
■
can cause an electric shock.
Do not operate the charger on easily
■
flammable surfaces (e.g. paper,
textiles etc.) or in a flammable
environment. Risk of burning due to high
temperatures generated by the charger during
charging.
If used incorrectly, battery fluid may
■
escape. Avoid contact with it. Rinse
with water after accidental contact. If
the fluid comes into contact with your
eyes, seek medical attention. Escaping
battery fluid can cause skin irritation or burns.
Use only genuine Würth accessories
■
and spare parts. When using non-rec-
ommended accessories, you may receive
incorrect measuring values.

Device elements

Overview [fig. I]
1 Mode indicator
2 Button for inclining and vertical lines
3 Button for manual, automatic or ADS mode
4 Battery power indicator
5 Keypad
6 Carrying handle
7 Battery compartment
8 Charging socket and charger LED
9 Mains adapter
10 Button for operation with hand-held receiver
11 Button for inclining and vertical lines
12 ALARM display
13 Button for horizontal lines