Installation Layout; Sensor Installation - V2 WES-SENSOR Manual Del Usario

NOTE: in order to guarantee optimal system operation, it is
important that the distance between the sensors and the
base be as short as possible and never exceed the
maximum permitted distance.
In addition, it is important to avoid positioning metal
surfaces between the base and sensors.

SENSOR INSTALLATION

WARNING: Sensors should be installed with the
system in operation, hence with the control unit on: make
sure the automation device cannot start a manoeuvre
during installation.
In the case of open air installations, the sensor must be
fitted vertically, with the cable outlet facing downwards.
1. Use fixing lug M on the cover and the two fixing lugs N on
the base to fix the sensor.

INSTALLATION LAYOUT

1 WES base (installed inside the motor)
2 WES sensor controlling 2 edges
3 WES sensor
4 WES sensor: recommended position for large gates
2. To open the casing, loosen either the cover by unscrewing the
screw in lug M, or the base by unscrewing the screws in lugs
N, then unscrew screw O which joins both parts of the
casing.
3. Remove the grommet Q; pass the edge connecting wires
through the hole in the base and then through the grommet.
4. Pass the wires through the anti-slip channel G and connect
them to the terminals.
5. Insert the narrow end of the grommet in the hole and pull
outwards so that the grommet snaps into position.
6