Blade Replacement - FOM INDUSTRIE SIKA PLUS Manual - Uso - Mantenimiento

GB
SIKA PLUS

10.3 BLADE REPLACEMENT

WARNING:
Disconnect the air system and lock the main switch off with the padlock before carrying out any parts
substitution.
Wear gloves
Hold the inner guard with one hand at point "A" - Fig. 10-02 and with the other unscrew and remove "B" - Fig. 10-
02.
Raise the inner guard all the way up exposing the blade. Insert wrench "C" as shown in Fig. 10-03 and give a sharp
hammer blow.
A
B
10-02
Hold wrench "C" - Fig. 10-03, unscrew and remove "D" - Fig. 10-04, locking the flanges and blade.
Pull out flange "E" - Fig. 10-04 and remove the blade. Check if the motor shaft and flanges are clean and oil them all
before fitting the new blade.
In this process, check the direction of rotation.
Tighten flange "E" - Fig. 10-04 with screw "D" - Fig. 10-04 and lock it all with a hammer blow on screw "C" - Fig. 10-
03.
Lower the safety guard and, holding it at point "A" - Fig. 10-02 screw in and tighten "B" - Fig. 10-02.
10-03
D
E
54
C
10-04