Operation; Installation; Power Up Screen; Front Panel Controls - Techne BLoCKICE Manual Del Usuario

INSTALLATION

See also the sections on Safety and Installation.
1. Place the unit on a suitable flat bench or in a fume cupboard if required, ensuring that the air vents
on the rear and underside are free from obstruction.
2. Plug the mains cable into the socket on the back of the instrument.
3. Place the required block inserts inside the unit. Up to two standard block inserts or one 96-well
block insert can be used.
4. Connect to the mains electricity supply with the plug provided or one wired correctly for the supply.
Switch the power ON from the switch located next to the mains input lead. The front display will
then light up.

POWER UP SCREEN

When first switched on, the display will show the name of the product and then show the current
temperature of the unit. The unit will then proceed to heat or cool to the last set temperature.

FRONT PANEL CONTROLS

The front panel consists of four buttons for
setting the unit temperature and timer and a 5
digit LED display.
The SET Button
Use this button to view and set the temperature,
set the timer to count up or down, set the count
down time and set the temperature units.
The PLUS Button
Use this button to increase a temperature
or time value and to start the timer.
The MINUS Button
Use this button to decrease a temperature
or time value and to pause the timer.
The TIMER button
Use this to view the set count down time
and to start the timer.

OPERATION

LED Display LED Display
set set
SET SET
Button Button
PLUS Button PLUS Button
16
O O
BL BL CKICE CKICE
timer timer
- -
+ +
MINUS Button MINUS Button
TIMER TIMER
Button Button