Axis P3365–VE Manual Del Usuario página 18

Note
To avoid moisture-related problems it is recommended that the cables are routed to the
camera from below with the cable holes facing downwards.
To route cables through the wall:
1.
Mounting bracket
2.
Network cable with gasket
3. Unit casing
4.
Remove gaskets from holes
1. Using the drill template drill 4 holes in the wall.
2. Route the network cable (and the I/O, audio cable if necessary) through the wall and
through the holes in the mounting bracket.
3. Attach the mounting bracket to the wall using 4 screws appropriate for the wall material.
4. Remove the camera unit from the unit casing by pushing the springs aside.
5. Remove the gaskets from the back holes in the unit casing. If there is only one cable,
remove only one gasket.
6. Route the cables through these holes.
7. Drag the gaskets along the cables and plug them into the holes. The gaskets should fit
snugly in the holes with no folds or bends.
8. Attach the unit casing to the mounting bracket by tightening the four screws.
AXIS P3365–VE Fixed Dome Network Camera
1
2
18
3
4