Omega 91000 Instrucciones De Funcionamiento Y Manual De Piezas página 5

PREPARATION
Before assembling your Folding Creeper, make sure all parts are present. Compare parts with package contents
list and illustrations. If any part is missing or damaged, do not attempt to assemble, install or operate the product.
Contact Omega customer service for replacement parts. Packaging Contents: 1 Creeper Body with cushions, 6
Casters, 6 Caster Lock Nuts.
ASSEMBLY
1. Carefully unfold the creeper until flat. Engage spring loaded Locking Pins.
CAUTION: Folding components can present pinch and crush hazards during normal use of this product.
!
Exercise caution when performing adjustments and while assembling and using this equipment.
2. Attach Casters to creeper frame caster brackets
using 17mm nuts.
OPERATION
1. Locate and unlock spring loaded Locking Pin for
middle section by pulling out until disengaged.
Then rotate Head Frame and Middle Frame
upward as shown in Fig. 7 until the Locking Pin
can engage hole in Creeper Seat locking plate
(ensure Lock Pin is fully engaged). This is the
low seat configuration.
2. Disengage Lock Pin for Middle Frame and rotate
further forward. Engage locking pin. Disengage
Lock Pin for Head Frame section and rotate
backwards as shown in Fig. 8. Adjust hinged
caster brackets as required. This is the high
seat configuration.
CAUTION: Ensure all Lock Pins are properly
!
engaged before using creeper.
Figure 9 - Creeper configuration
Figure 6 - Caster Assembly
Figure 7 - Low seat configuration
Figure 8 - High-seat configuration
3. Adjust hinged caster brackets so wheels will contact
ground properly. Unlock spring loaded Lock Pins,
then reverse steps 1 and 2, as shown in Fig. 9, to
convert Creeper Seat into Creeper.
5