Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PRODUCT DESCRIPTION - MODEL 92450
This device is designed to support and transport, along a smooth and level surface, one person, tools, and equipment
weighing *450 lbs. or less for the purpose of performing automotive maintenance or service. This device is not
intended, designed or engineered to be used for any other purpose.
Rated Capacity: One (1) person weighing 450 lbs. or less- * includes person, tools, equipment, personal items
SPECIFICATIONS
Model
Rated Capacity
92450
450 lbs
Before beginning assembly of product, make sure all parts are present. Compare parts with package contents list
and Figure 10 illustration. If any part is missing or damaged, do not attempt to assemble, install or operate the
product. Contact customer service for replacement parts.
Package Contents List
Item
Description
A
Tool Box Sub-Assembly
B
Caster Fasteners
C
Rear Tool Tray
D
Flat Washer
E
Swivel Caster
F
Front Frame Section
G
#2 Philips Screw
H
Front Tool Tray
J
Hexhead-Philips Screwdriver Tool
ASSEMBLY INSTRUCTIONS
A Hex Key-Philips Screwdriver Combo Tool (J) is provided and should be the only tool needed to complete assembly.
1. Join frame sections by inserting front frame section (F) into channel sections of tool box subassembly (A). Line
up screw holes and thread screws (G) fitted with washers (D) into corresponding holes in channel sections. Do
not tighten screws yet.
2. Assemble a caster (E) and a tool tray (C or H) simultaneously. Position a caster stud into lower frame hole as
seen in Figure 10. Place tool tray into position by aligning the lower frame thru-hole with corresponding hole in
tool tray. Insert caster fastener into the swivel caster stud.
3. Repeat assembly above for remaining casters and tool tray. Once tool trays have been successfully installed,
hand tighten all assemblies with provided Combo Tool.
4. Ensure casters swivel and roll easily. Check Tool Box drawers for ease of movement. Store extra key in a secure
place for future use.
OPERATING INSTRUCTIONS
Understand and follow all warning information.
1. Load tool drawers carefully. Pull drawer open to remove, push to close.
2. After using a tool, wipe clean and dry before returning it to the tool box.
3. The toolbox seat is NOT suitable for storing flammable, combustible, or corrosive materials.
!
Keep hands away from pinch and laceration hazards points that are created during use! Be alert
and sober when using this product! Sit centrally on seat pad ONLY. NEVER sit on edge!
Overall Toolbox
Dimension
Length, Width, Height
18-1/4" x 14-1/8" x 18-7/8"
Qty
1
4
1
2
4
1
2
1
1
(ref. Figure 10)
(Refer to Fig. 10)
Tool Drawer Inner
Dimension
Length, Width, Height
12-3/4" x 8-7/8" x 1-3/8"
J
H
F
Figure 10 - Assembly
6
B
A
D
G
E
C
Publicidad
Tabla de contenido
