Leuze electronic DDLS 500 Manual Del Usario página 18

EN
Safety
This optical data transmission system was developed, manufactured and tested in
line with the applicable safety standards. It corresponds to the state of the art.
Intended use
Devices of the DDLS 500 series have been designed and developed for the opti-
cal transmission of data in the infrared range.
Areas of application
The devices of the DDLS 500 series are intended for data transmission between
stationary and/or moving devices:
– The devices must – with respect to the transmission beam spread - be posi-
tioned opposite one another without interruption.
– A data transmission path consists of two devices designated with
"Frequency F3" and "Frequency F4" or two devices that are both designated
with "Frequency F0" on the name plate.
CAUTION
Observe intended use!
The protection of personnel and the device cannot be guaranteed if the
device is operated in a manner not complying with its intended use.
Ä
Only operate the device in accordance with its intended use.
Ä
Leuze electronic GmbH + Co. KG is not liable for damages caused
by improper use.
Ä
Download the device operating instructions: www.leuze.com
Ä
Read this supplement and the operating instructions for the device
before commissioning the device. Knowledge of these documents
is required in order to use the equipment for its intended purpose.
NOTICE
Comply with conditions and regulations!
Ä
Observe the locally applicable legal regulations and the rules of
the employer's liability insurance association.
Foreseeable misuse
Any use other than that defined under "Intended use" or which goes beyond that
use is considered improper use.
In particular, use of the device is not permitted in the following cases:
– in rooms with explosive atmospheres
– for medical purposes
NOTICE
Ä
Observe the safety notices on intended use and foreseeable mis-
use in the operating instructions for the device.
18