Installation; Mounting Options - ETI Solid State Lighting 53505111 Guía De Uso Y Cuidado

installation

WarninG: RISK OF ELECTRIC SHOCK. Ensure the electricity to the wires you are working on is shut off. Either remove the fuse or turn off
the circuit breaker before removing the existing light fixture or installing the new one.
If replacing a previous direct wire fixture, with power disconnected to the electrical box, remove the existing fixture. Make a sketch of how
the current fixture is wired (by wire color) or mark the wires with masking tape and a pencil so you will know how to properly reconnect the
wires to the new LED light fixture.

Mounting Options

This undercabinet light can be installed either by mounting directly to the underside of the wood cabinet with screws or by installing the
MagnaMount™ mounting plate and attaching the light to the magnetic plate.
1
Installing using the MagnaMount™ mounting plate
□ Position the mounting plate (FF) against the underside of the cabinet where you want the fixture to be mounted and mark the
locations of the three screw holes (Model# 53505111) or 4 screw holes (Model# 53506111) with a pencil. Take the mounting
plate (FF) down away from the cabinet once the location has been marked.
□ Place a short mounting screw (JJ) into the hole on one end of the mounting plate (FF) and attach an O-ring (BB) to the end of
the mounting screw (JJ) to hold it in place. Repeat with the remaining mounting screws (JJ).
□ If attaching to drywall instead of to the underside of a cabinet, drill pilot holes and tap in the drywall anchors (EE) at the screw
positions.
□ Hold the mounting plate (FF) up to the cabinet, matching the screw positions to the locations marked on the underside of the
cabinet.
□ Use a power tool to tighten the mounting screws (JJ).
□ Position the under cabinet light fixture (A) on the MagnaMount™ mounting plate (FF) and adjust the alignment as needed.
nOTe: Only 3 of the 4 short mounting screws included are used to install the MagnaMount mounting plate for Model 53505111. All 4 of the
short mounting screws are used to install the MagnaMount mounting plate for Model 53506111.
A
FF
EE
4
FF
BB
JJ