Linking Feature - ETI Solid State Lighting 53505111 Guía De Uso Y Cuidado

installation (continued)
5
Operating the light fixture
□ Use the toggle switch on the light fixture to control the lights.
□ If the under cabinet lights are installed on a dimming circuit, use
the dimmer switch to adjust the brightness.
nOTe: Color of light warms from 3000K to 2200K when dimmed.

Linking Feature

WarninG: RISK OF ELECTRIC SHOCK. Disconnect power to the under cabinet light before linking additional under cabinet lights.
□ Multiple light fixtures can be connected,
up to a maximum of 300 total watts.
Only the first light fixture needs to be
plugged into an electrical outlet or
directly wired.
□ Provide power to the fixtures only after
all linking connections have been made.
□ Connect each additional fixture using either the
linking cable (HH) or end-to-end connector (II).
Remove the end cover and insert either the end-
to-end connector (II) or linking cable (HH) into
the receptacle in the end of each under cabinet
light fixture (A). When using the linking cable
(HH), the maximum distance between two light
fixtures is 14.5 in. using the linking cable (HH)
provided.
□ Use wire clips (CC) to affix the linking cable (HH)
to the underside of the cabinet, if desired.
Model No . Part No .
53505111 UC-32-10-930-SV-D
53506111 UC-42-15-930-SV-D
A
Maximum Connected Units
18
14
7
Toggle Switch
A
Please contact 1-855-384-7754 for further assistance.
A
HH
A
II
www.ETiSSL.com