Connection Diagrams - CAME R Serie Manual De Instrucciones

and on the same plane;
- Secure the TX and ❺ ❻ boards and connect them as shown
in the diagrams , , or ;
DELTA-SI fi gure - On masonry wall set up the DOC-S ❷, sink-in
containers, positioning them at the same height and plane.
While, on metal posts, perforate with a hollow ø 60 ⓒ casing
bases ❸.
- Perforate ⓐ from the back, the container bases to allow cables
to pass through (use a cable gland ❾); hen secure the bases
using supplied screws and ORs ❼;
- Connect the TX and RX ❺ boards as shown in the , , or
diagrams and then snap in onto the container bases, sliding
them along their apposite rails ⓓ;
DELTA-SE / DELTA-SI - Close the container base using the
screw ❽ hooking in and turning the front piece ❹ from top
towards the bottom.

Connection diagrams

Figure - Connecting one opening pair during closing.
Figure - Connecting two reopening pairs (of the Delta S + Dir
series) during closing.
Figure - Connecting two pairs: one reopening during closing
ⓔ and one in partial stop ⓕ.
For the C-NC output contacts, always check the connection/
functioning instructions in the relative Came control panel manual.
To shift to the 12 V power mode (24 V being the standard), you
need to bridge the bonding pads on the RX boards, components
side on DELTA-SE (fi gure or on the opposite side on DELTA-SI
(fi gure ).
The data and information reported in this installation manual are susceptible to change at any time and without obligation to notify users.
Decomissioning and disposal
The packaging components are made of different materials, most
of which (paper, plastic, etc.) are fi t for solid urban waste disposal
and recycling.
Always check pertinent local legislation before acting.
While, other components such as control boards and transmitter
batteries and so on, and any other hazardous materials must be
removed and handed to specialised waste disposal fi rms.
DO NOT DISPOSE OF IN THE ENVIRONMENT!
Declaration
STAMENT OF COMPLIANCE
Pursuant to Electromagnetic Compatibility Directive.
CAME Cancelli Automatici S.p.A. hereby
declares under its own liability, that the
following gate and garage door automation
products, called:
DELTA-SE / DELTA-SI
Comply with the essential prerequisites
and applicable provisions, set forth by the
following Directives and applicable parts of
the reference Standards:
R
EFERENCE CODE TO REQUEST COPY OF THE ORIGINAL
DDC E D006
2004/108/CE - Electromagnetic
Compatibility Directive
2006/95/CE - Low Voltage Directive
Standards
EN 61000-6-1, EN 61000-6-2, EN
61000-6-2, EN 60335-1, EN 13241-1.
: