DOMUS LINE LOOP Manual De Instalación página 8

INSTALLATION MANUAL
WARNING
Safety is guaranteed is these instructions are followed and
therefore they must be kept. Installation may require the
involvement of qualified personnel. Before proceeding with
installation of the device, ensure that the environmental
conditions are in conformity with and suitable for the
characteristics of the product. Before any operation on the
device disconnect mains power.
DEVICE WITH MAGNET
The LOOP Magnet and PULSE Magnet models refer to
configurations of the devices fitted with a magnet. We
therefore recommend not keeping devices or any type of
magnet-sensitive support, such as credit cards, mass storage
devices, mechanical timepieces, measuring devices, etc. in
the immediate vicinity of these lighting devices. The
minimum recommended distance is at least 10cm from the
device in order to prevent damage should these devices come
into contact with these products.
EN
CONFIGURATIONS
The installation and operation instructions in this manual are
valid for all configurations of the LOOP and PULSE devices,
between which there are some differences. The LOOP and
PULSE models refer to the configurations of the devices fitted
with mounting systems for direct installation on the edge of
the mirror. The LOOP Magnet and PULSE Magnet models
refer to configurations of the devices fitted with a magnet for
direct installation on the mirror surface appropriately fitted a
with rear metallic sheet.
INSTALLATION OF LOOP AND PULSE
The LOOP and PULSE devices can be installed directly on the
edge of the glass of a mirror no thicker than 6 mm.
- Position the device's clamp (A) on the mirror (B) as
illustrated in figures 1 and 2 and then tighten the bracket
using the grub screws (C). Ensure that the grub screws (C)
are suitably secured for the purpose of guaranteeing
installation of the device.