Briteq BEAMBAR10-RGBW Manual De Instrucciones página 13

ENGLISH
ELECTRICAL INSTALLATION VIA ETHERNET IN/OUT:
Art-Net is nothing more than a protocol for transmitting DMX512 over an Ethernet network, developed by
Artistic Licence Engineering (UK) Ltd. Thanks to the much bigger bandwidth it is possible to send more than
256 DMX-universes in one time.
This projector can be connected in such Ethernet network using routers, switches etc. The network topology
is exactly the same as for a normal PC-network. However, IP-addresses cannot be obtained via DHCP: see
the explanations in the chapter "setup menu" on how to manually setup the IP-address, Net Mask and
choose the desired DMX-universe.
IMPORTANT NOTE: this projector has both Ethernet input and output so you can daisy chain several units.
However the number of units in one chain should be limited to ±10 units to avoid unwanted signal delays. In
bigger installations you should use the "STAR-topology" using Ethernet switches (or a combination of both):
 Internally the selected DMX-universe is treated as a normal DMX-signal so further setup of the DMX-
address, channel mode etc. should be done as usual.
 Thanks to the internal Art-Net node all 512 channels of the selected DMX-universe are automatically
converted from Art-Net to the DMX-output: they can be used to control other DMX-equipment:
BRITEQ
®
11/86
OPERATION MANUAL
BEAMBAR5+10-RGBW