BriskHeat IBC Manual De Instrucciones página 3

TOT Series: Units with Velcro Closures

Designed for specific size. See identification label.
INSTALLATION / OPERATION INSTRUCTIONS
Read and understand this entire manual
before operating this heater.
STEP 1
Remove heater from box. Make visual inspection of heater. Do not use if torn or damaged.
STEP 2
For units with adjustable nylon straps and buckles:
Heater should be placed on a clean, dry surface. Locate "mouse-hole" on heater. Loosely
wrap heater around IBC / tote tank with the mouse-hole positioned to accommodate the exit
spigot. The adjustable thermostat control knobs must be facing outside (if applicable) and
power cord exiting at the bottom of the heater. Secure the two top straps by fastening the
quick-release plastic buckle. Overlap the side of the heater with the nylon straps secured
closest to the edge on the outside, over any additional amount of the flap underneath.
Secure and tighten the bottom, middle and top straps. All five straps should now be firmly
tightened so the heater is tight against the tote tank / IBC with no sagging or bundling.
Cover the top of the tote tank / IBC with optional insulation cover.
®
© BriskHeat Corporation. All rights reserved.
Wrap-Around Tote Tank /IBC Heater
(TOTE & TOT Series)
The use of two individuals is
highly recommended for this
installation.
5
STEP 2 continued
For units with hook and loop fastener closure:
Heater should be placed on a clean, dry surface. Loosely wrap heater around IBC / tote
tank with the hook and loop fastener openings positioned to accommodate the exit spigot.
The adjustable thermostat control knobs must be facing outside (if applicable) and power
cord exiting at the bottom of the heater. Secure the two top straps by attaching the hook
and loop fastener. Attach hook and loop fastener closure on the side so heater is tight
against the tote tank / IBC with no overlapping, sagging or bundling. Cover the top of the
tote tank / IBC with optional insulation cover.
Note: Units with hook and loop fastener are designed for an exact size. DO NOT overlap
heater.
STEP 3
Plug standard 3-prong plug (if applicable) to appropriate electrical power supply. The power
connection must be adequately rated to electrically support the voltage and amperage of
the heater. The identification label located on the power cord displays voltage and
amperage requirements. Follow all local electrical codes for proper electrical connections
STEP 4 (For units with adjustable thermostats)
Adjust temperature control knobs to desired settings on both top and bottom zones. Heater
can be adjusted 50-160°F (10-71°C).
STEP 5 (Optional IBC/Tote Tank Insulator)
PN: TOTE-TOP
Universal Size: 48"x48" (1,200mm x 1,200mm)
Install optional IBC/Tote Tank Insulator by disconnecting the buckle of one of the two top
straps and sliding the insulator underneath the remaining top strap. Reconnect the top strap
buckle and tighten both straps if necessary. Depending on the size of your IBC/Tote Tank,
tuck excess insulator between the IBC/Tote Tank and the heater (see Image).
®
© BriskHeat Corporation. All rights reserved.
Wrap-Around Tote Tank /IBC Heater
(TOTE & TOT Series)
6
.