Fb200 Warranty Statement; Compliance - Fisher Scientific FB200-2 Manual Del Operador

FB200 Warranty Statement

The Fisher Scientific Company ("Fisher") warrants to the direct purchaser that the FB200 will be
free from defects in material or workmanship for a specified warranty period. During that period,
Fisher will repair or replace the product or provide credit, at its sole option, upon prompt
notification and compliance with its instructions. For FB200 power supplies that specified period
is 48 months from manufacturing date.
Unless otherwise agreed, the warranty is limited to the country in which the product is sold.
No Fisher employee, agent or representative has the authority to bind Fisher to any oral
representation or warranty concerning any product sold. Any oral representation or warranty
made prior to purchase of any product and not set forth in writing and signed by a duly authorized
officer of Fisher shall not be enforceable by the purchaser.
FISHER EXPRESSLY DISCLAIMS ALL OTHER WARRANTIES, EXPRESS OR IMPLIED,
INCLUDING THE IMPLIED WARRANTY OF MERCHANTABILITY AND FITNESS FOR A
PARTICULAR PURPOSE.
Fisher's sole responsibility and the purchaser's exclusive remedy for any claim arising out of the
purchase of any product listed above is repair, replacement or credit as described above, where
applicable. In no event: 1) shall the cost of the exclusive remedy exceed the purchase price: 2)
shall Fisher be liable for any special, indirect, incidental, consequential, or exemplary damages,
howsoever arising, even if Fisher has been advised of the possibility of such damages.
Each article that Fisher furnishes will conform to the written specifications given in this manual,
or those of a further improved model. Changes are made often to the information in the manual
and will be incorporated into future editions.

Compliance

Pertaining to models: FB200-1
EMC - This equipment when used in accordance with the instruction manual conforms to EMC
Directive 89/336/EEC and EMC Standard EN61326, as applicable to electrical equipment for
measurement control and laboratory use.
IEC - This equipment has been designed and tested to conform to Low Voltage Directive
73/23/EEC and IEC 1010-1 Safety Standards, as applicable to electrical equipment for
measurement control and laboratory use.
FB200-2 MANUAL
FB200-2
Page 9 7608175 Rev A 8/02