Blue Connect Guia De Inicio Rapido página 115

Declaration of conformity FCC
Changes or modifications not expressly
approved by Riiot Labs SA could void the user's
authority to operate the equipment.
For devices with a serial number that begins
with a 4.
FCC Part 15 compliance statement
This device complies with part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference
that may cause undesired operation. NOTE:
This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits
are designed to provide reasonable protection
against harmful interference in a residential
installation. This equipment generates uses
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instruction, may cause harmful interference to
radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception which can be determined by turning
the equipment off and on, the user is encouraged
to try to correct interference by one or more of
the following measures: - Reorient or relocate
the receiving antenna. - Increase the separation
between the equipment and receiver. - Connect
the equipment into an outlet on circuit different
from that to which the receiver is connected. -
Consult the dealer or an experienced radio/TV
technician for help.
Industry Canada Licence-Exempt Radio
Apparatus
This device complies with Industry Canada
licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this
device may not cause interference, and (2) this
device must accept any interference, including
interference that may cause undesired operation
of the device.
Le présent appareil est conforme aux CNR
d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est
autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage,
et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le
brouillage est susceptible d'en compromettre le
fonctionnement.
Radio Frequency (RF) Exposure Compliance of
Radiocommunication Apparatus
To satisfy FCC and IC RF Exposure requirements
for mobile devices, a separation distance of
20 cm or more should be maintained between
the antenna of this device and persons during
operation. To ensure compliance, operation at
closer than this distance is not recommended.
This transmitter must not be co-located or
operating in conjunction with any other antenna
or transmitter.
Conformité à l'exposition aux champs RF des
équipements radio
Pour satisfaire aux exigences FCC et IC
concernant l'exposition aux champs RF pour les
appareils mobile, une distance de séparation de
20 cm ou plus doit être maintenu entre l'antenne
de ce dispositif et les personnes pendant le
fonctionnement. Pour assurer la conformité, il
est déconseillé d'utiliser cet équipement à une
distance inférieure. Cet émetteur ne doit pas être
co- situé ou fonctionner conjointement avec une
autre antenne ou un autre émetteur.
Declaration of conformity CE
For devices with a serial number that begins
with a 3.
Hereby, Riiot Labs S.A. declares that the
radio equipment type Blue Connect Smart
Pool Analyser is in compliance with Directive
2014/53/EU. The full text of the EU declaration of
conformity is available at the following internet
address: www.blueconnect.io/legal
SIGFOX : Tx : 868.13MHz / 14dBm max Rx :
869.525MHz
Bluetooth LE : 2400-2483.5MHz / 10dBm max
Authorized countries codes:
ALB – AND – AUT – BEL– BIH – BLR – BUL – CYP –
CZE – DNK – EST – FIN – GRC – HNG – HOL –
HRV – IRL – ISL – LIE – LTU – LUX – LVA – MDA –
MKD – MLT – MNE – NOR – POL – POR – ROU –
SRB – SUI – SVK – SVN – TUR