Maintenance; Spare Parts; Important - Omcan Santos 28 Manual Del Suaurio

damaging the machine. The quantity of products to be processed before reaching the maximum filling level
in the container (6) varies according to the products being processed. If during preparation an imbalance
should occur well before the pulp container is full, it is sometimes appropriate to continue adding food for
the imbalance to be cleared. But if the imbalance continues, the machine must be stopped and the basket
assembly (5) cleaned. Certain products are liable to clog or block the sieve holes, in which case the basket
assembly (5) should be cleaned more frequently.
Before carrying out any work on the juice extractor, the machine must be unplugged from the mains power
supply and the motor start capacitor discharged:
Discharging the capacitor: Use a screwdriver with insulated handle to touch the 2 connectors on the capacitor
(13). The appearance of an electric arc shows that the capacitor has discharged (Fig. 14).

SPARE PARTS

IMPORTANT: Use of spare parts other than certified original parts is prohibited. This machine requires no
particular maintenance because the bearings are lubricated for life. If any maintenance is necessary to replace
parts subject to wear, such as the grater, the basket, electrical or other components, please refer to the parts
list.
For the machine to operate properly, it is recommended that a check is also made that the locking membrane
(21) is in good condition, in particular the absence of any signs of tearing. Also check that the elastomer drive
sprockets (22) are in good condition, in particular the absence of any signs of wrenching. For all spare part
orders (see the Parts Breakdown section of the manual), state the type, the appliance serial number and the
electrical specifications recorded under the appliance.
SERVICING
Do not use a hose or a pressurize water jet for cleaning.
• After use, clean the basket assembly, bowl, cover, pulp container, plunger in clean water or with a dish
washing detergent product designed for this purpose. Then rinse and dry. Do not use abrasive products or
pads to clean the basket assembly.
• The base is to be cleaned with a soft damp sponge, then dried.
CAUTION
For easier cleaning, do not leave food remains to dry on the bowl (4), the basket assembly (5), the cover (2),
or the fruit plunger (3). It is recommended that all these parts of the machine are cleaned immediately after the
work is finished.
RECYCLING THE PRODUCT AT THE END OF ITS SERVICE LIFE
This equipment is marked with the selective sorting symbol relating to wastes from electrical and electronic
equipment. It signifies that this product should be taken over by a selective collection system conforming to the

Maintenance

9