Fellowes Neptune A3 Manual De Instrucciones página 5

FEATURES & TIPS
AutoSense
Unique system detects pouch thickness and self-adjusts to
optimal lamination setting.
Lamination Feed Sensor
When the machine senses a pouch has been mis-fed or has not
gone completely through the machine in normal operating time,
the machine will stop the lamination process, the Reverse button
LED will blink, and a beep will sound. Press and hold the reverse
button on the front of the machine to remove the laminate.
'Reverse' function
To eject the laminating pouch during use, press and hold
down the reverse button until the pouch has ejected from the
machine.
'Sleep Mode' function
If the machine is not active for 30 minutes, the 'Sleep Mode'
function will place the machine into standby mode. To operate
the machine, press the 'Power On' button on the control panel.
BEFORE LAMINATING
1.
Ensure the machine is on a stable surface.
2.
Check there is enough clear space (min 50cm) behind the
machine to allow items to pass through freely.
STEPS TO LAMINATE
5.
Switch the power on (located at the rear right side of the
machine).
6.
The Standby button will turn on with a soft blue glow.
7.
Press the 'Standby' button on the control panel. The Auto
display will flash. The auto display will turn solid and a
beep will sound when the laminator is ready.
8.
The machine will automatically warm-up to the hot pouch
(auto) setting. Note: the laminator features AutoSense
which automatically recognises the pouch thickness you
insert into the laminator. The laminator automatically
adjusts for hot pouches from 75 micron to 175 micron.
9.
When the machine has indicated it's ready, place the pouch,
sealed edge first, into the pouch / document entry. Keep
the pouch straight and central within the document entry,
not on an angle. Use the entry markings as a guide.
Auto
Auto (Hot)/Cold
Cold
The Auto (hot)/cold button is used to toggle back and forth
between hot and cold laminating.
For best results, use Fellowes ® brand pouches:
Enhance 80, Impress 100, Capture 125, Protect 175.
This machine does not need a carrier to laminate. It is a
carrier-free mechanism.
Always put the item to be laminated into the appropriate
sized pouch.
Always test laminate with a similar size and thickness
before final process.
Prepare pouch and item for lamination. Place item
within pouch centred and touching the leading sealed
edge. Ensure the pouch is not too large for the item.
If required, trim excess material from around the item
after lamination and cooling.
3.
Plug the machine into an easily accessible mains socket.
Switch the mains supply on.
4.
Fit the Exit Tray to the rear of the machine.
10.
If cold lamination is desired, press the cold button at
any time and the cold button will blink blue. When the
laminator is ready for cold lamination the cold display
will turn solid and a beep will sound. Note: to use the cold
setting after hot lamination you may have to wait for the
laminator to cool down for 30 – 60 minutes.
11.
To switch back to hot pouch laminating after cold
laminating, press the Auto (hot)/cold button.
12.
Upon exit, the laminated pouch is hot and soft. Remove the
pouch immediately. Place pouch onto a flat surface to cool.
This helps prevent any jamming.
5