Master/Slave Operation - Ibiza Light LP64 LED-PROMO Manual De Instrucciones

Installation
The unit should be mounted via its screw holes on the bracket. Always ensure
that the unit is firmly fixed to avoid vibration and slipping while operating.
Always ensure that the structure to which you are attaching the unit is secure
and is able to support a weight of 10 times of the unit's weight. Also always use
a safety cable that can hold 12 times of the weight of the unit when installing
the fixture.
The equipment must be fixed by professionals. And it must be fixed at a place
where is out of the touch of people and has no one pass by or under it.
How To Control The Unit
There are three ways to operate the unit:
A. Master/Slave operation
B. Easy sound active and Auto mode
C. Universal DMX controller
A. Master/Slave operation
In master/slave mode you can link as many units together in a days-chain to
perform the built-in pre-programmed lighting shows triggered by music.
For Master/Slave mode please refer to the DMX settings below:
Master unit: when working at Auto-run or Sound Control mode operation
Slave units: DMX start address MUST be set to d001. (First DIP switch = ON, all
other are OFF)
B. Easy sound active and Auto mode
Set sound active mode:
DIP switch #10 = ON,
Set the speed with the DIP switches # 1-6 = ON, all others are OFF
Set Auto mode:
DIP switch # 9-10 = ON, Set the speed with the DIP switches # 1-6 = ON, all
others are OFF
C. Universal DMX controller
When using a universal DMX controller to control the chain of units, you have
to set DMX address by Dip switches from 1 to 9 to make sure all the units will
receive its DMX signal.
Please refer to the following diagram to know how to address your DMX 512
system in the binary code.
©Lotronic – 2014 www.ibizalight.com