Before Fi Rst Use; Using The Kettle - Sencor 179-NAB1 Serie Manual De Usuario

Variable Temperature Kettle
SWK 179XXX-NAB1 / SWK 1791WH-NAB1 / SWK 1792BK-NAB1
BEFORE FIRST USE
1. Remove all wrapping material from the variable temperature kettle and its base.
2. Fill the variable temperature kettle with pure water up to the maximum water mark. Boil the water
and empty the contents of the kettle. Repeat this process 2 to 3 times.
Note:
To boil water in the variable temperature kettle, proceed according to the instructions in the
chapter Using the kettle.
3. Now the variable temperature kettle is ready for use (for preparing hot beverages, etc.).

USING THE KETTLE

1. Set the desired length of the power cord. Push the power cord into the groove in the base A3.
Place the base A3 on a stable, even and clean surface.
2. Fill the variable temperature kettle with the required amount of drinking water. Fill the kettle
through the opening after lifting the lid A5. The lid A5 will open when button A4 is pressed.
The water level must reach at least the minimum mark (0.5 l) and must not exceed the maximum
mark (1.7 l).
Warning!
Never fi ll the kettle when it is placed on the base.
If the kettle is overfi lled, boiling water may splash out.
Be sure the lid is closed before heating water. The lid will be warm to the touch after heating.
3. Place the kettle on the base A3. Make sure that the lid A5 is properly closed. Insert the power
plug into an electrical power socket. After connecting the power cord to the electrical power
socket, a sound will be made and the current water temperature will appear on the display.
Note:
If the water temperature in the kettle is lower than 104°F (40°C), the display will show "Lo" (low
temperature).
4. This variable temperature kettle offers the selection of several modes and their combinations, as
described below:
4.1 Boil water
Press button B4 to set the boil water mode. Button B4 and the water level mark A8 will be lit.
The variable temperature kettle will start heating the water. As soon as the water starts to boil,
a sound will be made (5 beeps) and the kettle will turn off automatically (switches to stand-by
mode). The lights of button B4 and the water level mark A8 will switch off. The current water
temperature will be shown on the display B1.
Note:
This mode can be canceled at any time by pressing button B4.
4.2 Heat water to a preset temperature and maintain the preset temperature
Use button B3 to set the heating temperature 122, 140, 158 or 185°F (50, 60, 70 or 85°C). The
temperature setting changes each time the button B3 is pressed. To set the maintain water
temperature mode, press button B2. When buttons B2–3 and the water level mark A8 are lit,
it is heating water. Display B1 will switch to the current water temperature display mode. The set
temperature is indicated by the "•" symbol lit up on the display B1. The variable temperature
kettle will start the heat water mode. As soon as the water reaches the preset temperature, the
kettle will beep. Afterwards, the variable temperature kettle will switch to the maintain preset
2014
EN-9
10/2014