Before First Use; Using The Kettle - Sencor 1010WH-NAB1 Guia Del Usuario

SWK 1010WH-NAB1 / SWK 1011GR-NAB1 / SWK 1012BL-NAB1 / SWK 1013OR-NAB1 / SWK 1014RD-NAB1 /
SWK 1015VT-NAB1 / SWK 1016YL-NAB1 / SWK 1017TQ-NAB1 / SWK 1018RS-NAB1

BEFORE FIRST USE

1. Remove all wrapping material from the kettle and its base.
2. Fill the kettle with clean water up to the maximum water mark. Boil the water and empty the
contents of the kettle. Repeat this process 2 to 3 times.
Note:
To boil water in the kettle, follow the instructions in the chapter "Using the kettle".
3. Now the kettle is ready for use and for preparing hot beverages, etc.

USING THE KETTLE

1. Set the power cord to the desired length. Push the power cord into the groove in the base A4. Put
the base A4 on a stable, even, clean surface.
2. Fill the kettle with the required amount of water. The water level must reach at least the minimum
mark – 10,1 fl.oz (0.3 l) but not exceed the maximum mark – 33.8 fl.oz (1 l). You can fill the kettle
through the spout or through the opening when the lid A1 is lifted. To open the lid A1, press
button A2. After filling the kettle with water, close the lid A1 and push it down so that it is secured
in the closed position.
Warning!
Never fill the kettle if it is on the base A4.
If the kettle is overfilled, boiling water may splash out.
3. Put the kettle on the base A4. Insert the power plug into an electrical socket. Check that the lid
A1 of the kettle is closed.
4. Start the kettle by moving the switch A5 to position I (ON). The Power On light A8 will go on.
Attention:
Do not turn on the kettle if it is empty. Improper use of the kettle may shorten its useful life.
If you accidentally turn on the kettle without water, after it reaches a certain temperature, the
thermostat will, interrupt the electric circuit and the Power On light A8 will go off. The kettle
can be used again after several minutes, as soon as its stainless-steel bottom has cooled down.
5. As soon as water boils, the kettle will turn off automatically and the Power On light A8 will turn
off. Before taking the kettle off the base A4, check that it has turned off automatically. If it has
not automatically turned off, turn off the kettle manually by moving the switch A5 to position 0
(OFF).
Note:
The kettle's operation can be stopped at any time by moving the switch A5 to position 0 (OFF).
6. Pour the boiled water into a prepared container, cup or mug. Make sure that the kettle remains
in a horizontal position when it is carried, particularly if it is filled all the way up to the maximum
mark. If you wish to open the lid A1 to refill the kettle, first empty all the contents of the kettle so
that you are not scalded by the escaping steam.
7. After you finish using the kettle, unplug it. Empty the kettle and allow it to cool down.
2017
Electric Kettle
EN-8
06/2017