Before First Use; Using The Kettle - Sencor SWK 1810WH-NAB1 Guia Del Usuario

SWK 1810WH-NAB1 / SWK 1811GR-NAB1 / SWK 1812BL-NAB1 / SWK 1813OR-NAB1 /
SWK 1814RD-NAB1 / SWK 1815VT-NAB1 / SWK 1816YL-NAB1 / SWK 1817TQ-NAB1 / SWK 1818RS-NAB1

BEFORE FIRST USE

1. Remove all wrapping material from the kettle and its base.
2. Fill the kettle with clean water up to the maximum water mark. Boil the water and empty the
contents of the kettle. Repeat this process 2 to 3 times.
Note:
To boil water in the kettle, follow the instructions in the chapter "Using the kettle".
3. Now the kettle is ready for use and for preparing hot beverages, etc.

USING THE KETTLE

1. Set the power cord to the desired length. Push the power cord into the groove in the base A4. Put
the base on a stable, even, clean surface.
2. Fill the kettle with the required amount of water. You can fill the kettle through the spout or
through the opening when the lid is lifted. To open the lid, press the safety lid lock A4. The water
level must reach at least the minimum mark – 16.9 fl. oz. (0.5 l) and must not exceed the maximum
mark – 60.9 fl. oz. (1.8 l).
Warning!
Never fill the kettle if it is on the base.
If the kettle is overfilled, boiling water may splash out.
3. Put the kettle on the base. Insert the power plug into an electrical socket. Check that the kettle's lid
is closed.
4. Start the kettle by moving the switch to position I (On). The Power On light will go on.
Attention:
Do not turn on the kettle if it is empty. Improper use of the kettle may shorten its useful life. If
you accidentally turn on the kettle without water, the thermostat will, after reaching a certain
temperature, interrupt the electric circuit and the Power ON light will turn off. The kettle can be
used again after several minutes, as soon as its stainless-steel bottom has cooled down.
5. As soon as water boils, the kettle will turn off automatically and the Power ON light will turn
off. Before taking the kettle off the base, check that it has turned off automatically. If it has not
automatically turned itself off, turn off the kettle manually by moving the switch to position 0 (OFF).
Note:
The kettle's operation can be stopped at any time by moving the switch to position 0 (OFF).
6. Pour the boiled water into a prepared container, cup or mug. Make sure that the kettle remains in
a upright position when it is carried, particularly if it is filled all the way up to the maximum mark. If
you wish to open the lid to refill the kettle, first empty all of its contents so that you are not scalded
by the escaping steam.
7. After you finish using the kettle, unplug it. Empty the kettle and allow it to cool down.
2017
Electric kettle
EN-8
06/2017