Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
DMX Linking
The Ovation ED-200WW will work with a DMX controller using a 3- or 5-pin DMX data connection. A DMX Primer is
available from www.chauvetprofessional.com.
DMX Connection
The Ovation ED-200WW uses a 3- or 5-pin DMX data connection for its DMX personalities: UNO, DOS, and STD.P. See
the User Manual for information about connecting and configuring the product for DMX operation.
Master/Slave Connection
The Ovation ED-200WW uses the DMX data connection for its Master/Slave mode. See the User Manual for information
about connect and configure the product for master/slave operation.
RDM (Remote Device Management)
Remote Device Management, or RDM, is a standard for allowing DMX-enabled devices to communicate bi-directionally
along existing DMX cabling. The Ovation ED-200WW supports RDM protocol that allows feedback to monitor
temperature and changes to ADDRESS, PERSONALITY, DIMMER, and PWM menu options. Download the User
Manual from
www.chauvetprofessional.com
Dimmer Control
The Ovation ED-200WW may be plugged into and controlled using a regular dimmer. In this mode, the product reacts
exactly like an incandescent product. See the User Manual to configure Dimmer Control operation.
Mounting
Before mounting this product, read the
mounting clamps are capable of supporting the weight of the product. For our CHAUVET Professional line of mounting
clamps, go to http://trusst.com/products.
Mounting Diagram
Safety Cable
Secure the safety
cable using the
passageway on
the back of the
product
Lens Tubes
The following lens tubes are available for purchase:
•
19°, 26°, 36°, and 50° w/Gel frame (6.25 in/159 mm accessories)
•
15°–30° and 25°–50° Zoom Gel frame (7.5 in/191 mm accessories)
Passcode
After being prompted, enter the following passcode: <UP>, <DOWN>, <UP>, <DOWN>, <ENTER>.
This passcode cannot be changed and must be used whenever prompted.
Ovation ED-200WW QRG Rev. 1
QUICK REFERENCE GUIDE
for more details.
Safety
Notes. Use at least one mounting point per product. Make sure the
Mounting Clamp
EN
2
Publicidad
Tabla de contenido
