Copyrights, Etc; Installation Procedures - M-Audio AUDIOPHILE 192 Guía De Uso

Macintosh
< Macintosh G4 733 MHz or higher
< 512MB RAM
< Mac OS X Jaguar (10.2.8 or later) or Panther (10.3.4)
< Available PCI slot

Copyrights, etc

Windows, Windows XP, and Windows 2000 are trademarks of Microsoft Corporation.
Macintosh, Mac OS, Mac OS X and CoreAudio are trademarks of Apple Computer.
All other trademarks are property of their respective holders.

Installation Procedures

To Install the Audiophile 192
In all operating systems, begin by inserting the M-Audio Audiophile 192 driver CD-ROM into your computer's CD-ROM drive, then browse to the
installer file for your particular operating system. If your system has AUTORUN CD enabled, the installation wizard will take you through the install
process step by step. Refer to the section below for Windows or Mac specific instructions on running the installer software.
Once the software has been installed, open your computer and physically insert the Audiophile 192 firmly into an available PCI slot.
When hardware installation is complete, restart your computer and follow the instructions on completing the driver software installation.
Refer to the following sections for your particular hardware and operating system.
Windows XP/2000
Begin by inserting the M-Audio Audiophile 192 driver CD-ROM into your computer's CD-ROM drive and browsing to the installer file for your
particular operating system. If your system has AUTORUN CD enabled, the installation wizard (pictured) will take you through the install process
step by step.
Running the installer application by clicking "Next" will copy the necessary driver files to your computer's hard drive.
4