Handset Registration - AEG ECLIPSE 10 Guia De Inicio Rapido

8.2 Redial List
The redial list stores the last 10 numbers dialled. A maximum of 24 digits can be displayed for each entry.
8.2.1 Access the Redial List
• From the home screen, press
• Press on to browse the redial list.
> The last dialled number will appear first in the redial list.
> If the number has more than 14 digits press
9 SETTINGS
9.1 Set the Display Language
You can change the display language on your handset.
• From the home screen, press
• Press to "HANDSET OPTS" and then press
• Press to "LANGUAGE" and then press
• Press to select your preferred language and then press
> A confirmation tone is played.
• Press to return to standby mode.
Note: Once the display language is set, the handset will switch to display in the selected language
immediately.
9.2

Handset Registration

IMPORTANT: When you purchase your unit, all handsets are already registered to your base, so you do
not need to register them.
Handset registration is only necessary when you buy extra handsets or if a handset has become faulty.
You can register up to four handsets to one base station, with each handset's number (1 to 4) shown on
its display.
Note: Each handset can only be registered to one base.
You need to enter the Master PIN before you can register or deregister handsets. The default Master PIN
is 0000.
9.3 Register Additional Handsets
• Press and hold the
> The message indicator on the base will flash for up to 1 minute, while it is in registration mode.
• On the handset, press
• Press to "SETTINGS" and then press
• Press to "REGISTRATION" and then press
• Enter the Master PIN and then press
Note: After entering the Master PIN,
> WAITING flashes on the screen.
> A confirmation tone is played to indicate successful registration, and the handset returns to standby
mode, with its handset number displayed.
> If no base is found with the entered PIN, error tones are played to indicate failed registration and
"PLS REG H/S" is displayed on the screen. You will need to repeat from step 1 above.
> During steps 2-5, if no key is pressed on the handset within 10 seconds, the registration procedure will
be aborted. If this happens, repeat from step 1 above.
.
.
key under the base unit for approximately 5 seconds.
.
to confirm.
P
to see other digits.
to select.
to select.
to confirm.
to select.
to select.