AEG ECLIPSE 10 Guia De Inicio Rapido página 7

6.1.4 Call from the Call Log
• Press in standby mode.
• Press to select the desired entry in the call log and then press
number.
Note: You need to subscribe to Caller Line Identification service to be able to see the caller's number or
name in the call log.
6.1.5 Call from the Phonebook
• Press in standby mode.
• Press to select the desired entry in the phonebook and then press
phonebook number.
6.2 Answer and End a Call
• When the phone rings, press on your handset.
• To end a conversation, press on your handset.
Warning: When the handset is ringing, please do not hold it too close to your ear as the volume of the
ringing tone may damage your hearing.
Note: You can simply place the handset back on its base station to end the call, provided you have not
deactivated the Auto hang-up feature.
6.3 Handset Speakerphone
During a call, you can press to alternate between hands-free speakerphone and handset earpiece.
6.4 Adjust Earpiece Volume
There are 5 levels of earpiece volume on your Handset.
• During a call, press
> The current setting is shown.
> When you end the call, the setting will remain at the last selected level.
6.5 Adjust Speaker Volume
There are 5 levels of speaker volume.
• During a handsfree call, press
> The current setting is shown.
> When you end the call, the setting will remain at the last selected level.
6.6 Mute/Unmute the Microphone
• When the microphone is muted, the handset displays "MUTE ON" and your caller cannot hear you.
• During a call, press
6.7 Paging
The paging feature enables you to locate a missing handset if the handset is in range and contains
charged batteries.
• Press the key under the base unit.
> All the registered handsets that are in range will start to ring.
You can stop the paging by pressing any key on a handset or the
to select from "VOLUME 1" to "VOLUME 5".
to select from "VOLUME 1" to "VOLUME 5".
to turn on/off the microphone.
to dial out the selected call log
to dial out the selected
key under the base unit again.