AEG ECLIPSE 10 Guia De Inicio Rapido página 4

4 INSTALLING YOUR PHONE
4.1 Connecting the Base Station (See P4)
• Plug the mains power cable (15) and telephone line cord (16) into the base station.
• Plug the power adapter into a 100 - 240Vac, 50 - 60Hz mains power socket and the telephone line cord
into a telephone line socket.
Warning: Always use the cables provided in the box. Use only the supplied adaptor. Using other power
adapter may damage the unit.
Note: Place the base unit within easy reach of the mains power socket. Never try to lengthen the mains
power cable. The base station needs mains power for normal operation and the cordless handsets will
not work without it.
4.2 Installing and Charging the Rechargeable Batteries
• Insert the 2 supplied batteries into the battery compartment, observing the correct polarity (see markings
inside battery compartment).
Warning: Use only the supplied NiMH rechargeable batteries.
• Place the back cover over the back of the handset and press down until it clicks into place.
• Place the handset on the base and charge for 15 hours before using the handset for the first time.
> The handset will give a double beep when it is properly placed on the base and the battery charging
indicator on the base lights up to indicate charging.
Note: The handset may become warm when the batteries are being charged or during prolonged periods
of use. This is normal and does not indicate a fault.
CAUTION
Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to
the instructions.
4.3 Removing the back cover of the Eclipse Handset (See P5)
Insert the supplied key into the groove as indicated in the illustration and twist it clockwise to release the
back cover.
5 GETTING TO KNOW YOUR PHONE
5.1 Overview of the Handset and Base Station
# Icon
1
2
3
In standby mode, press to enter the Main Menu list.
Press to select an item, or to save an entry or setting.
In menu mode, press to scroll up.
During a call or message playback, press to increase the volume.
In standby mode, press to access the call log (CID).
In standby mode, press to make or answer a call.
During a call, press to send a Flash signal for network services.
Meaning