Commands & Instruments Description; Commands; Installation; Connections - Saeco IDEA CUP SCT004 Manuel De Uso Y Mantenimiento

English
4 - COMMANDS &
INSTRUMENTS
DESCRIPTION
4.1

Commands

The machine is equipped with the following switches:
Main switch (ref. 3, fig. 1)
Push this key to switch the machine on.
Upper plate switch (ref. 4, fig. 1)
Push this key to enable the heating element for the
upper cup warming plate.
Lower plate switch (ref. 4, fig. 1)
Push this key to enable the heating element for the
lower plate.

5 - INSTALLATION

Operation falling within the competence of the Mainte-
nance technician.
5.1

Connections

The connection will have to be implemented by observing
the national safety rules.
Carry out connections by proceeding as follows:
- Check that the surface upon which the appliance is to be
placed is firm.
- Drill a hole in the plate (ref.D, see NB, fig. 5) as shown.
- Install the appliance on the surface top and level it by adjust-
ing the height of the special feet (ref. A, fig. 4).
- Connect with the power supply by way of the relevant cord
(ref. B, fig. 5).
N.B.: It is possible to connect the drip tray (ref. 6, fig. 1) directly
to a discharge tube by proceeding as follows:
- drill the surface top as shown (ref. D, fig. 5);
- join a discharge tube to the fitting (ref. C, fig. 4), by way
of a suitable hose clamp.
12
The connection point (electrical socket) must be placed in
an easily accessible position, in order to disconnect the
appliance from the mains, should this be necessary.
In case of accidental damage to the power cord, have it
replaced by the Maintenance technician.
A
fig. 4
Appliance surface top
132,5
A
D
A
53
Legend:
A - Positioning of adjustable feet
D - Hole for water drain channel and power
cord (hole Ø 60)
fig. 5
To facilitate the connection operations, the diameter of the
drilling holes on the surface top will be greater than that
of tubes and cables indicated in the legend of fig. 5.
B C
132,5
A
A
318