Grandstream GXP2110 Guia De Inicio Rapido página 4

PHONE SETUP:
Installing the phone (Wall Mount):
1. Attach the two wall mount spacers to the slot for wall mount spacers on the
back of the phone.
2. Attach the phone to the wall via the wall mount hole.
3. Pull out the tab on from the handset cradle (See figure below).
4. Rotate the tab and plug it back into the slot with the extension up to hold the
handset while the phone is mounted on the wall (See figure below).
3
Wall Mount Holes
are available
Slot for the phone
stand if placing the
phone on the table
Slot for the wall
mount spacers if
placing the phone
on the wall
Handset Rest
Tab with extension up
Tab with extension down
Installing the phone (Phone Stand) :
For installing the phone on the table with the phone stand, attach the phone stand
to the bottom of the phone where there is a slot for the phone stand. (Upper half,
bottom part).
CONNECTING THE PHONE:
Extenstion
Module Port
PC Port LAN Port Power
To setup the GXP2120/GXP2110, follow the steps below:
1. Connect the handset and main phone case with the phone cord.
2. Connect the LAN port of the phone to the RJ-45 socket of a hub/switch or a
router (LAN side of the router) using the Ethernet cable.
3. Connect the 5V DC output plug to the power jack on the phone; plug the power
adapter into an electrical outlet.
4. The LCD will display provisioning or firmware upgrade information. Before con-
tinuing, please wait for the date/time display to show up.
5. Using the phone embedded web server or keypad configuration menu, you can
further configure the phone using either a static IP or DHCP.
Handset Port
Headset Port
4