lancer XBT-L1000 Manual De Instrucciones página 11

3 - Content of the dialogue table
The dialogue table is different accoding to the XBT-F / TXBT-F selected. The list of functions
accessible for each type, together with the default table for each, is given below.
Control device :
Functions
Static function key images
System key images
Numerical key images
Communication check
Control PLC time set
N° of application page displayed
N° of last field entered
N° of last acknowledged alarm
Last acknowledged alarm groups
Status - Report
Load factor log
Curve plotting complete
N° of page to be processed
N° of field to be entered
Application signature
Print command
Curve plot command
Table write enable
Recipe transfer inhibit
Deletion history
Static function key LEDs on
Static function key LEDs flashing
Dynamic function key LEDs on
Dynamic function key LEDs flashing
Lock static function keys
Lock system keys
Lock numerical keys
Alarms table
Magelis Graphic terminal time set
Free format print table
UNINTENTIONAL DAMAGE OPERATION
PLC memory zone allocated for the XBT dialog table must NOT be used for anything else. Itis
designer's responsability to program PLC logic properly.
Failure to observe this precaution can result in deth, severe personal injury or equipment
WARNING
damage.
W9 152 6284 0111 A 04
Modbus Plus protocol
XBT-F01 / F02
11
XBT-F03
09 - 1999
E
N
G
L
I
S
H