Designated Use Of The Amt150; Warning Notice; Repair And Maintenance - ALFRA AMT150 Instrucciones De Operación

Designated use of the AMT150

The AMT150 is used to set up and wire mounting plates up to max. 1100 x 1900 mm W x H.
Heeding all instructions and observing the prescribed operating conditions
forms part of the designated use.

Warning notice:

1. Do not overload the assembly table! Prior to any use, there should be a check that the
prescribed maximum load of 150 kg will not be exceeded.
2. During use, no one should remain sitting or standing on the assembly table.
3. Make sure that the loaded assembly table has been secured against unintended rolling.
4. Ensure that the load is evenly distributed over the assembly table's entire work surface.
5. The assembly table was designed for even, firm surfaces and is therefore not suitable for
sloping, uneven surfaces.
6. Loading and unloading should only be carried out in the horizontal position.
7. The assembly table was designed for enclosed areas and is therefore not suitable for work in
the open air.

Repair and maintenance

Repair and maintenance should be carried out regularly, as it extends the operating life of the
assembly table.
The following examination should be carried out prior to any use:
1. The various parts of the assembly table should not be bent or twisted.
2. Test the functioning of the brakes and check the wheels for wear.
3. Lubricate the moving, wearing parts prior to use.
4. If there are defects, repairs should be carried out promptly.
5. The pipe guides and the lifting spindle should be lubricated once per month.
8