LiftMaster STAR1000 Manual Del Usuario página 3

PROGRAMMING COMMANDS
The table below describes the commands used to program the receiver.
MAIN MENU COMMAND
LEARN MENU LEARN DEVICE
BLOCK LEARN DEVICE
LEARN TO LOC #
DELETE MENU DELETE DEVICE
DELETE ALL DEVICES
SUSPEND MENU SUSPEND DEVICE
SUSPEND ALL DEVICES
UNSUSPEND DEVICE
UNSUSPEND ALL DEVICES
QUERY MENU LOC # USED
LOC # AVAILABLE
LOC # SUSPENDED
SETTINGS CHANGE PIN
DEALER INFO
FIRMWARE VERSION
BEEP
MEMORY
RELAY
CONTRAST
LANGUAGE
FACTORY DEFAULT
DIAGNOSTICS
The receiver emits a series of audible beeps to signal programming and
error events. The table at right lists all of the events and their audible
notifications. The On/Off column indicates that the audible notification for
the event may be disabled in the BEEP SETTINGS menu.
DESCRIPTION
Program a device to the receiver.
Block program a range of devices to the receiver.
Program a device to a 4-digit number location.
Delete a specified device that has been programmed to the receiver.
Delete all programmed devices.
Temporarily disables the function of a specified device that has been
programmed to the receiver.
Temporarily disables the function of ALL devices programmed to the
receiver.
Re-enable the function of a suspended device.
Re-enable the function of ALL suspended devices.
Displays a range of used locations starting from a specified location.
Displays a range of empty locations starting from a specified location.
Displays a range of suspended locations starting from a specified
location.
Change the 6-digit PIN number for the receiver.
Display and edit the dealer 11-digit contact phone number.
Displays the current firmware version.
Turn the audible feedback on or off.
DUPLICATE MEMORY
Creates a memory backup. A backup memory module must be
installed.
RESTORE MEMORY
Restores a memory backup from a memory module.
NOTE: Content of memory backup module will over-write any
information already stored in the receiver memory.
Sets the relay activation time from .25 to 1 second.
Press Down or Up arrows to adjust LCD contrast.
Sets menu language: English (Default), Spanish, and French.
Reset receiver to factory default settings.
EVENT
Key press
Successful Add
Successful Delete
Successful Suspend
Successful Unsuspend
Master PIN entry error
Programming error
Location out of range
Generic Success
Generic Error
Received unknown Tx
Received known Tx
Received known suspended Tx
3
AUDIBLE ON/OFF
NOTIFICATIONS
Single YES
Double
Triple
Double
Double
Long
Long
Long
Double
Long
Slow YES
Double YES
Long YES