HQ-Power VDP575MHW16 Manual Del Usuario página 4

CHANNEL 4
CHANNEL 5 SCAN SPEED ADJUST
CHANNEL 6 LAMP ON / OFF AND RESET
CHANNEL 7
CHANNEL 8
CHANNEL 9
CHANNEL 10
CHANNEL 11 CMY COLOUR CHANGE SPEED
CHANNEL 12 CMY COLOUR EFFECT WHEEL
CHANNEL 13
CHANNEL 14
CHANNEL 15 SHUTTER , STROBE
CHANNEL 16
c. DMX-512 Connections
Connect the provided XLR cable to the female 3-pin XLR output of your controller and the other side to the male 3-
pin XLR input of the VDP575MHW16. Multiple VDP575MHW16s can be linked through serial linking. The linking
cable should be two core, screened cable with XLR input and output connectors.
Please refer to the diagram at the right.
Caution: At the last fixture, the DMX cable has to be terminated with a terminator.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with the
fixture or one fixture with another.
VDP575MHW16
TILT FINE
COLOUR
CYAN
MAGENTA
YELLOW
EFFECT WHEEL
ZOOM
DIMMER
0 255 Fine control of TILT movement (16 bit)
0 255 Fast / Slow
0 127 No function
128 139 Lamp on after 3 sec, reset
140 229 No function
230 239 Lamp off after 3 sec.
240 255 No function
0 24 White
25 49 Red
50 74 Blue
75 99 Green
100 124 Orange
125 149 Increase colour temperature clip (6000K)
150 174 Decrease colour temperature clip (3200K)
175 199 Ultraviolet wave filter (firefly light)
200 255 Rainbow effect from slow to fast
0 255 White / Cyan
0 255 White / Magenta
0 255 White / Yellow
0 255 From fast to slow.
0 7 White beam (CMY under control)
8 13 White beam
14 28 Colour 1
29 43 Colour 2
44 58 Colour 3
59 73 Colour 4
74 88 Colour 5
89 103 Colour 6
104 118 Colour 7
119 133 Colour 8
134 148 Colour 9
149 163 Colour 10
164 178 Colour 11
179 193 Colour 12
194 208 Colour 13
209 223 Colour 14
224 238 Colour 15
239 253 Colour 16
254 255 Colour 17
0 49 Beam out
50 99 Lambency
100 255 Radiate lambency in clockwise direction
0 255 28° - 7°
0 9 Shutter closed
10 40 Beam out
41 250 Strobe
251 255 Beam out
0 100 Black / Brightness
4 HQ POWER