LaserLiner Duraplane G360 Manual De Usuario página 14

The anti-drift system (ADS) prevents erroneous or inaccurate
measurements. How it works: continuous monitoring of the
alignment of the laser is activated 20 seconds after the ADS is
switched on. If the device moves due to external influences or
if the laser loses its height reference, the laser switches off and
the tilt LED lights up permanently. Press the tilt button twice
to continue. Erroneous and inaccurate measurements are thus
prevented simply and reliably.
The ADS is not active following switch-on. Once the device has
been set up, press the tilt button to activate the ADS, enabling
you to protect the laser from changes in position caused by the
device being disturbed by external factors. The tilt LED flashes to
indicate that the ADS function is active; see the diagram below.
The ADS does not activate the monitoring function until 20 seconds
!
after the laser levelling procedure has been completed (set-up phase).
The tilt LED flashes every second during the set-up phase, rapid
flashing, when ADS is active.
ADS function
ON
Automatic level
set-up phase
Green laser technology
Laser modules in DLD design stand for high line quality as well
as a clean and clear and therefore easily visible line image.
Unlike previous generations they are more temperature-stable
and energy efficient.
14
EN
ADS active after 20 seconds,
rapid flashing of the tilt LED.
ADS activation:
press the tilt
button; the tilt
LED flashes every
second.
External
influence
The
laser
switches off and
the tilt LED is lit
continuously.