Publicidad
Section 5
Attach Side Bows to Header/Fabric Assembly (cont.)
Step 2
486.52 (Right)
Right Underside
Step 2
Insert the end of the Right Side Bow into the
hole in the right side of the Header/Fabric
Assembly, aligning the two holes in the
tubing with the two holes in the header.
Make sure that the Spring Catch faces in.
Secure the Right Side Bow in place with
(4) #8 x 1/2" Pan Head Washer Screws:
two from the underside of the Header/Fabric
assembly, and two from the topside.
Repeat on left side, using Left Side Bow.
P11 - 54822 - Rev. C 0213
Step 2
2
1
Installation Instructions - Supertop NX Twill
(cont.)
3
Right Topside
Hardware
Pan Head
Washer Screw
Qty. 4 per side
Part # 393.79
Step 3
Header/Fabric Assembly
2
1
Right Underside
Step 3
Replace the protective flaps on both sides,
and re-insert the screws you set aside, two
for each side.
Page 11
© 2013 Bestop, Inc.
Publicidad
